Filter
Top Products
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 767
53-1001931-01
Chapter
25Smart RF Instance
In this chapter
•smart-rf config commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 767
Use the
(config-wireless-smart-rf) instance to configure Smart RF related configuration
commands. To navigate to the
config-wireless-smart-rf instance, use the following
commands:
RFController(config)#wireless
RFController(config-wireless)#smart-rf
RFController(config-wireless-smart-rf)#
smart-rf config commands
The following table summarizes config-wireless-smart-rf commands:
TABLE 27 Smart-RF Configuration Commands
Command Description Ref.
assignable-po
wer-range
Specifies the power range during power-assignment page 769
auto-assign Enables individual RF parameters to be auto-assigned page 770
clrscr Clears the display screen page 771
end Ends the current mode and moves to the PRIV EXEC mode page 772
exit Ends the current mode and moves to the previous mode page 773
extensive-sca
n
Enables the extensive-scan mode, calibrations to be made at
every tx-power level
page 774
help Displays the interactive help system page 775
hold-time The number of seconds to disable interference avoidance
after a detection
page 776
no Negates commands or resets values to default page 777
number-of-res
cuers
Sets the number of rescuers to cover for faulty radios page 781
radio Smart RF radio related commands page 782
recover Enables individual self-recovery features page 785
retry-threshold Sets the average number of retries before a channel scan is
performed
page 786
run-calibrate Starts a new automatic RF calibration process page 787
scan-dwell-tim
e
Sets the time duration to dwell on a channel during channel
scan
page 788