Filter
Top Products
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 511
53-1001931-01
DHCP Config commands
17
class
DHCP Config commands
Associates a DHCP class with a pool
This command is used in Step 4 of Creating a DHCP User Class.
The CLI prompt moves to a sub-instance
(config-dhcp-class).The configuration mode changes
from
(config-dhcp)# class to (config-dhcp-class).
Refer to config-dhcp-class on page 512 for a
(config-dhcp-class) command summary.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
class <class-name>
Parameters
Example
RFController(config-dhcp)#class RFControllerDHCPclass
RFController(config-dhcpclass)#
Creating a DHCP User Class
Follow the steps below to create a DHCP User Class:
1. Create a DHCP class named
RFControllerDHCPclass. The controller supports a maximum of
32 DHCP classes.
RFController(config)#ip dhcp class RFControllerDHCPclass
RFController(config-dhcpclass)#
2. Create a USER class named MC800. The mode changes to (config-dhcpclass). The controller
supports a maximum of 8 users classes per DHCP class.
RFController(config-dhcpclass)#option user-class MC800
RFController(config-dhcpclass)#
3. Create a Pool named WID, using (config)# mode.
RFController(config)#ip dhcp pool WID
RFController(config-dhcp)#
4. Associate the DHCP class, created in Step 1 with the pool created in Step 3. The controller
supports the association of 8 DHCP classes with a pool.
RFController(config-dhcp)#class RFControllerDHCPclass
RFController(config-dhcp-class)#
5. The controller moves to a new mode (config-dhcp-class). Use this mode to add an address
range used for the DHCP class associated with the pool.
class <class -name> Associates a class with a pool and enters the DHCP pool
class configuration mode