![](http://pdfasset.owneriq.net/c/9c/c9ceb723-53f1-4484-9e87-1ae9320ad42f/c9ceb723-53f1-4484-9e87-1ae9320ad42f-bg1ff.png)
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 509
53-1001931-01
DHCP Config commands
17
address
DHCP Config commands
Specifies a range of addresses for the DHCP network pool
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
address range <low IP address> <high IP address>
Parameters
Usage Guidelines
Use the
address command to specify a range of addresses for the DHCP network pool. The DHCP
server assigns IP address to DHCP clients from the address range. A high IP address is the upper
limit for providing the IP address, and a low IP address is the lower limit for providing the IP
address.
Use the
no address range command to remove the DHCP address range.
Example
RFController(config-dhcp)#address range 2.2.2.2 2.2.2.50
RFController(config-dhcp)#
range <low IP address>
<high IP address>
Adds an address range for the DHCP server
• low IP address – Defines the first IP address in the
address range
• high IP address – Defines the last IP address in the
address range