Filter
Top Products
HOW TO USE ON-SCREEN PROGRAMMING (OSP) AND HELP KEY
3-3
Level one
function
Level two
function
Explanation of Options
Factory
setting
Chapter
4.CONTRAST
1.
TEMP.
(TEMPO-
RARY)
SETTINGS
2.CANCEL
JOB
3.
PRINT
REPORTS
4.SET
QUICK-
DIAL
5.USER
OPTIONS
2.BEEPER
1.
SMOOTHING
3.SETUP
GROUPS
2.SPEED-
DIAL
1.
ONE-TOUCH
DIAL
See page 13-1
for a list of
reports.
7.
COVERPAGE
6.OVERSEAS
MODE
5.
RESOLUTION
AUTO
STAN-
DARD
OFF
OFF
ON
LOW 4
7
4
4
4
13
6
6
6
6
6
There are three types of contrast setting. Usually
the AUTO setting is acceptable. But if you want to
send or copy an especially light or dark document,
you should change this setting.
AUTO: Default is AUTO. Contrast setting always
reverts to AUTO after one transmission.
LIGHT: To send very light documents.
DARK: To send very dark documents.
If you need to send a set of originals at various
resolutions, this function will allow you to set the
required resolution page by page. (If all documents
are the same resolution, use the Resolution. See
chap. 2.)
STANDARD/FINE/S. FINE/PHOTO
If you have trouble when sending overseas, you
may want to set OVERSEAS MODE to ON.
ON/OFF
An automatic Cover Page will allow you to send
details of when the fax was sent and from whom it
was sent. ON/OFF
If you wish to cancel a job that has been set with the
timer, a polled job etc., use this function.
You can print several different lists and reports,
which are available under this function.
If you register names and numbers on One-Touch
dial keys, you can dial a number automatically just
by pressing a One-Touch key. (Max. of 24 locations)
If you register names and numbers as Speed-Dial
numbers, you can dial a number automatically just
by pressing Speed-dial and a two-digit number.
(Max. of 36 locations for FAX 1020 Plus and 100
locations for FAX 1030 Plus.)
This is used for setting up a group number used for
broadcasting.
Smoothing enhances the appearance of incoming
faxes.
If you set SMOOTHING to ON, you will receive
fax messages with the smoothing enhancement.
ON/OFF
You can adjust the volume of the beeper with this
function.
OFF/LOW/HIGH