Filter
Top Products
3-4
Chapter 3 Basic Operation
2. Placing Documents onto the Scanner
This section describes how to load documents into the feeder and how to position a document page on the flatbed (platen glass) for
scanning.
CAUTION
Handle documents with care. Improper handling of paper can cause paper cuts or other personal injury.
Loading a Document into the Feeder
Perform the following steps to load the pages of a document
into the feeder for scanning.
1. Adjust each slide guide so its pointer is aligned with
the corresponding paper size on the document size
label.
IMPORTANT
Use both hands to adjust both the left and right slide guides.
Adjusting only one slide guide can lead to a malfunction.
2. Align the edges of the document stack on a flat
surface, and then load the stack into the feeder with
the scanning side facing upwards.
Insert the stack into the feeder as far as it will go, until the
document set indicator lights.
IMPORTANT
• Make sure the top of the document stack is not higher than the
load limitation mark. Overloading the feeder can cause
jamming.
• The feeder is designed to hold approximately 100 sheets of
standard copy paper (20 lb bond or 80g/m
2
).
Slide Guide
Document Set Indicator
Load Limitation
Mark