Filter
Top Products
4-2
Chapter 4 User Modes
1. About the User Modes
You can configure the scanner settings with the user modes described below.
User Mode Functions
User mode functions are as follows:
■ Count Only Mode
ON: Counts the number of pages in a document using
stand-alone scanner operations. (See “Count Only
Mode” on p. 3-21.)
OFF: Normal Mode (default)
■ Long Document Mode
ON: Enables detection of documents up to 24.8" (630 mm)
long for auto document size detection. (See
“Documents” on p. 3-2.)
OFF: Enables detection of documents up to 17.0" (432
mm) long for auto document size detection (default).
IMPORTANT
• Long Document mode can only be used with applications that
support it.
• Configure the ISIS/TWAIN driver as follows. If the following settings
are not configured as shown, proper scanning may not be possible.
– Basic Setup Dialog Box (See p. 8-5.)
[Page Size]: [Auto-detection]
– Orientation Settings Dialog Box (See p. 8-11.)
[Document Orientation]: [90 degrees]
[Duplex Orientation]: [Calendar type]
– Advanced Settings Dialog Box (See p. 8-12.)
[Text Orientation Recognition] check box: Not selected
• Processing speed may slow down when scanning while the
Long Document mode is set.
• When scanning two-sided documents with the Long
Document mode set to ON, the documents will be scanned
one side at a time, regardless of the single-pass duplex
setting.
• When using the Long Document mode, if you place a long
document askew in the document tray, it will rub against both
sides of the feeding path and may damage the document.
Make sure to align the document straight when placing it in the
document tray.
• When using the Long Document mode, jam detection may not
work propery and document may be damaged. Be wary of
paper jams when using Long Document mode.
• When scanning a document that is 17" (432 mm) or more in
length, load the document one page at a time and scan.
■ Stand-by Mode
240:
Scanner enters Stand-by Mode after 4 hours of non-use.
60:
Scanner enters Stand-by Mode after an hour of non-use.
10: Scanner enters Stand-by Mode after 10 minutes of
non-use (default).
■ Display Language Mode
ON: Japanese
OFF: English (default)
■ Display Contrast Setting
Use the and keys to move the pointer ( ) to the left
for lighter contrast or to the right for darker contrast.
ON [ OFF ]
Count Onl y Mode
ON [ OFF ]
Long Document
240 60 [10]
Stand-by Mode
ON [ OFF ]
Japanese
Di splay Cont rast