Filter
Top Products
Follow this procedure to set up the printer for data transfer via the IrDA
interface
1.
The printer IrDA interface is on the left side of the printer, below the
parallel interface connector.
2.
Locate the IrDA interface on the computer. Arrange the printer so
the IrDA interface ports are facing one another.
The IrDA interface ports must face one another and be approximately
level, within a range of 15 degrees left or right, 15 degrees up or down
and not more than 1 metre (3 ft.) apart.*
*May vary depending on the specific computer, PDA, and communication protocol used.
The following conditions may reduce the reception range of the
IrDA interface.
• If another IrDA device is attached.
• If another infra-red device, like a set of wireless headphones or a
remote controller, for example, is broadcasting in the same area.
• If the IrDA port is exposed to sunlight, fluorescent light, or any
other strong light source like a large torch.
• If the IrDA port is not clean. Clean it with a soft, dry cloth if the
port is smudged or dirty.
24
Chapter 2 Setting Up the Printer
IrDA interface