Canon K10158 Printer User Manual


 
Colour printing problems
This section contains solutions for problems you may encounter when
printing in colour.
Printer prints only in black-and-white
If you are printing from a software application that supports colour
printing but your output is only in black ink, follow these steps.
1.
Make sure that you selected the BJC-50 printer driver or a
compatible driver for another colour printer.
2.
When you print from a DOS software application, make sure that
you use the BJC-50 printer driver, or you use a compatible driver for
another colour printer and the printer is set to LQ mode.
3.
Make sure the colour ink cartridge still contains ink to print the
Nozzle Check Pattern. (45) If any part of the colour pattern is
blank, the colour ink cartridge has run out of ink. Replace the empty
ink cartridge. (66)
Colours are broken or uneven
If colours are broken, uneven, or vary from line to line, follow these
steps.
1.
The print mode may be inappropriate for your graphics resolution. If
you are printing high-density graphics, set the printer driver to Fine
mode.
2.
If you are generating a thin line in a non-primary colour (not cyan,
magenta, or yellow), the software may tell the printer to dither the
line by printing alternate coloured dots and blank white areas. To
correct this, choose cyan, magenta, or yellow.
3.
Make sure the colour ink cartridge still contains ink to print the
Nozzle Check Pattern. (45) If any part of the colour pattern is
blank, the colour ink cartridge has run out of ink. Replace the empty
ink cartridge. (66)
92
Chapter 7 Troubleshooting