Problem See Page
Other Printing Problems
Strange characters 94
Print job halts before completion 95
Characters on the screen do not match printed characters 96
Printing beyond edge of page 96
IrDA printing stops and paper is ejected 96
Printer prints incorrect number of lines on a page 96
Computer indicates a device time-out 97
Printouts are incomplete (only 50% to 75% of the page )
or printed with large white bands 97
■
Errors indicated by the CHARGE/ERROR lamp
CHARGE/ERROR lamp lights and and buzzer beeps once.
If the sheet is too narrow (less than 100 mm), or if the sheet is inserted
diagonally, the buzzer will beep once, the CHARGE/ERROR lamp
will light orange, and the printer will eject the paper from the feed slot.
After the sheet is inserted again correctly, the printer will reverse feed it
slightly and the buzzer will not beep. If POWER lamp is flashing, data
remains to be printed. Press the RESUME button to finish the print job.
CHARGE/ERROR lamp lights and stays on and buzzer beeps
twice.
The printer could not eject the paper correctly because the paper is over
58 cm long (23 in.). Remove the paper. Break the print job into shorter
pages. The printer cannot feed and eject paper longer than 58 cm
(23 in.).
CHARGE/ERROR lamp lights and stays on and buzzer beeps
three times.
No BJ Cartridge is installed on the printer. Install a BJ Cartridge. (☞28)
CHARGE/ERROR lamp lights and stays on and buzzer beeps
six times.
The battery pack is not installed correctly in the printer. Press the
POWER button to switch the printer off and install the battery pack.
(☞19) Press the POWER button to switch the printer on again. If the
problem persists, replace the battery pack. (☞62) To avoid problems
with the battery pack, always use the printer within the correct
temperature range of 0°C to 35°C (32°F to 95°F).
CHARGE/ERROR lamp flashes green when power is off.
Battery pack is damaged. Replace the battery pack. (☞62)
Buzzer beeps six times when power is on.
Battery pack is damaged. Replace the battery pack (☞62)
84
Chapter 7 Troubleshooting