Canon K10158 Printer User Manual


 
7.
Insert the BJ Cartridge into the cartridge holder diagonally so the
points of the small triangle marks align (yellow-yellow, black-
black).
8.
Press down gently on the BJ Cartridge until it clicks into place.
9.
Press the CARTRIDGE button once. The printer starts cleaning the
print head. After print head cleaning is completed, the cartridge
holder moves to the home position.
10.
Close the top cover.
11.
Make sure you install the IS Scan scanner driver supplied on disk
with the printer. For details, refer to the supplemental sheet for
scanner diver installation.
You must install and use the IS Scan 1.20 scanner driver or higher. Earlier
versions of this scanner driver do not work correctly with the BJC-50.
Cleaning the printer
Before you start cleaning
You should clean the printer regularly to avoid printing problems.
Follow these simple guidelines when you clean the printer:
Before you clean the printer, press the POWER button to switch the
power off, unplug the AC adapter from the power source, and remove
the battery pack from the printer. (64)
Use only a soft cloth to clean the printer. Do not use paper towels or
tissues.
Do not clean the grease from the cartridge rail.
To avoid damaging the surface of the printer, do not clean the printer
body with volatile liquids such as thinners, benzene, or any chemical
or spray cleaners.
When cleaning the printer, avoid the area near the print head on the
BJ Cartridge. Do not touch the print head, film cable and other
delicate parts.
Never submerge the printer in water.
78
Chapter 6 Maintaining the Printer