Filter
Top Products
4-5
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 4 Installing or Replacing the Backup Battery
Installing a New Backup Battery
Step 3 Use a Phillips screw driver to remove the four screws attaching the backup battery to the cover
(see Figure 4-3).
Figure 4-3 Backup Battery Screws
Installing a New Backup Battery
Note The AIR-1520-BATT-6AH= backup battery is used only on access point models AIR-CAP1552E-x-K9
and AIR-CAP1552EU-x-K9. Do not use this battery on model AIR-CAP1552H-x-K9,
AIR-CAP1552SA-x-K9, or AIR-CAP1552SD-x-K9.
To install a new backup battery into your access point, follow these steps:
Step 1 Carefully orient your new backup battery as shown in Figure 4-3 over the access point radio cover.
Step 2 Position the backup battery over the four screw holes in the radio cover.
Step 3 Use the four supplied screws to attach the backup battery to the radio cover and tighten to 5.5 to 6.5 in.
lbs (0.62 to 0.73 Nm).
Step 4 Position and bend the backup battery cable as shown in Figure 4-3.
1 Battery backup screws (4 places) 3 Backup battery
2 Battery backup cable and connector 4 Access point radio cover