Filter
Top Products
2-14
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 2 Installing the Access Point
Mounting the Access Point
Step 3 When all bolts are hand-tightened, use a 13-mm closed-end wrench or socket to partially tighten the bolts
in the tightening sequence shown in Figure 2-6. Tighten each bolt to 3 to 4 ft lbs (0.34 to 0.45 Nm).
Step 4 Repeat Step 3 using the same tightening sequence to fully tighten each bolt to 6 to 7 ft lbs
(0.68 to 0.79 Nm).
Figure 2-6 Hinged Cover Bolt Tightening Sequence
Mounting the Access Point
This section provides instructions for installing your access points. Personnel installing the access point
must understand wireless access points and bridging techniques and grounding methods.
Caution All installation methods for mounting an access point on any wall surface is subject to the acceptance of
local jurisdiction.
Installation Options
There are two optional installation kits:
• Strand mount kit—Used for cable strand installations
• Pole mount kit—Used for pole, wall, or streetlight installations
1 - 6 Tighten the bolts in the numeric order shown, starting with 1.
255257
1
4
5
6
3
2