Filter
Top Products
2-13
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 2 Installing the Access Point
Installation Guidelines
Opening the Access Point Hinged Cover
You need to open the access point hinged cover when you are installing fiber-optic SFP module and fiber
cable take-up reels.
To open the access point hinged cover, follow these steps:
Step 1 Use 0.5-in (13-mm) box-end wrench or socket set to unscrew and remove the four bolts on the front cover
of the unit. Only unscrew the hinge bolts about 2 turns until they are easily turned by hand, do not remove
the bolts on the hinge (Figure 2-5).
Step 2 The cover is hinged on the bottom. Carefully open the cover and remove the cover.
Note If the cover does not open easily, carefully loosen the hinge bolts again.
Figure 2-5 Access Point Front View of Hinged Cover
Closing the Access Point Hinged Cover
To close the access point cover, follow these steps:
Step 1 When closing the access point cover, be careful not to pinch internal wires.
Step 2 Carefully position the cover flush with all sides of the access point, then slowly hand-tighten each bolt.
1 M8 x32 bolts 2 Cover hinge M8 x32 bolts
255250
1
2
1
1
1
2