Filter
Top Products
2-47
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 2 Installing the Access Point
Powering the Access Point
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit.
Statement 1028
Note If your access point contains a backup battery pack, you must press the reset button for 10
seconds or more (see the “Disabling Backup Battery Power” section on page 3-10).
Step 2 Ensure a 6 AWG ground wire is connected to the access point (see the “Grounding the Access Point”
section on page 2-41).
Step 3 Use an adjustable wrench, a 22-mm socket, or the Sealcon S-2200-WR wrench to remove the Ethernet
connector plug from the access point (see Figure 2-34 for the location).
Figure 2-34 Location of Ethernet Liquid-Tight Adapters (Only Models AIR-CAP1552E-x-K9 and
AIR-CAP1552EU-x-K9)
Note For information on data cable entry, refer to Figure 1-1 on page 1-6
Step 4 Loosen the round end of the liquid-tight adapter by turning counterclockwise, but do not remove (see
Figure 2-35).
1 PoE-in port 2 PoE-out port
45 6
255260
1 2