Filter
Top Products
3-141
Cisco Signaling Gateway Manager User Guide
78-15589-01
Chapter 3 Managing ITP Networks Using SGM
Working with Signaling Points
–
MIB Data Error
–
SNMP Exception
–
SignalingPoint Inactive
–
Linkset Inactive
–
Link Congested
–
Link Send Utilization Threshold Exceeded
–
Link Receive Utilization Threshold Exceeded
–
Link Local Interface Inactive
–
Link Remote Interface Inactive
–
Link Inactive
If the cell is too small to show all of the status reason, place the cursor over
the cell to see the full status reason in a mouse over help popup.
The status reasons are listed in order of decreasing magnitude. If two or more
reasons apply, the reason of greatest magnitude is displayed.
If the status reason is Unsupported Configuration, correct the configuration
and enter the sgm cleandiscover command to delete all current network data
and begin a clean discovery of the ITP network. If the status reason is still
Unsupported Configuration, enter the sgm clean command to restore the
SGM server to a “clean” state, such as would exist after a new installation of
SGM. For more information on the use of these commands, see the “SGM
Commands and Descriptions” section on page B-2.
Viewing Detailed Information for a Signaling Point
SGM can display detailed information about a selected signaling point, including
its associated linksets, links, status, and other information.
To display detailed information for a signaling point, use one of the following
procedures:
• Select Signaling Points in the left pane of the SGM Main Window,
right-click a signaling point in the right pane, then select
View>Configuration Details in the right-click menu.
• Select the turner beside Signaling Points in the left pane of the SGM Main
Window, then select a signaling point.