Filter
Top Products
Chapter 3 Managing ITP Networks Using SGM
Working with Signaling Points
3-146
Cisco Signaling Gateway Manager User Guide
78-15589-01
The status reasons are listed in order of decreasing magnitude. If two or more
reasons apply, the reason of greatest magnitude is displayed.
If the status reason is Unsupported Configuration, correct the configuration
and enter the sgm cleandiscover command to delete all current network data
and begin a clean discovery of the ITP network. If the status reason is still
Unsupported Configuration, enter the sgm clean command to restore the
SGM server to a “clean” state, such as would exist after a new installation of
SGM. For more information on the use of these commands, see the “SGM
Commands and Descriptions” section on page B-2.
Linksets Tab: Links
To view information about the links that are associated with the selected signaling
point, select the Linksets tab. SGM displays the linksets in the top table, and the
links in the bottom table.
To see mouse over help popup for each column in the table, place the cursor over
a column header.
If a cell is too small to show all of its data, place the cursor over the cell to see the
full data in a mouse over help popup.
You can resize each column, or sort the table based on the information in one of
the columns. See the “Resizing, Sorting, and Hiding Table Columns” section on
page 3-279 for more details.
By default, SGM displays all of the columns in the Link Table except Internal
ID, Congestion Level, and Last Status Change. To display these columns, or to
hide other columns, see the procedures in the “Modifying Linkset Table Column
Settings” section on page 5-18.
The Link Table displays the following information about links that are associated
with the selected signaling point:
• Internal ID—Internal ID of the link. The internal ID is a unique ID for every
event, linkset, link, signaling point, and node, assigned by SGM for its own
internal use. It can also be useful when the TAC is debugging problems.
• Node—Name of the node associated with the link.
• Signaling Point—Name of the signaling point associated with the link.
• Linkset—Name of the linkset associated with the link.
• SLC—Signaling link code (SLC) ID for the link.