Filter
Top Products
3-9
Compaq Professional Workstation AP500 Maintenance and Service Guide
Speaker
To remove the speaker:
1.
Perform the service preparations shown on page 3-2.
2.
Remove the side access panel.
3.
Unplug the speaker connector from the system board 1, and remove the cable from the
clip.
4.
Remove the four T-15 screws securing the front of the speaker to the chassis 2.
5.
Remove the speaker from the workstation by sliding it back, then lifting it up and out of
the chassis 3.
1
1
3
2
Figure 3-8. Removing the speaker
To replace the speaker, reverse the above procedure.