Filter
Top Products
3-17
Compaq Professional Workstation AP500 Maintenance and Service Guide
Removing the Card Guide
To remove the card guide:
1.
Perform the service preparations shown on page 3-2, then lay the workstation on its side.
2.
Remove the following components:
❏ Workstation feet
❏ Side access panel
❏ I/O bracket assembly
❏ Full-length expansion boards, if installed
3.
Using a blunt tool, press inward on the two center tabs on the card guide.
4.
Gently pull the card guide out.
Figure 3-13. Removing the card guide
To replace the card guide, reverse the above procedure.
IMPORTANT: Before replacing the I/O bracket assembly, read “Important Guidelines for I/O
Bracket Assembly Replacement” earlier in this chapter.