Filter
Top Products
3-35
Compaq Professional Workstation AP500 Maintenance and Service Guide
Removing the Fan from a Hard Drive Installed in
Bays 5 or 6
NOTE: This section only applies if there is a fan installed over Bays 5 and 6. The fan is required
only in high-altitude environments or when a hard drive faster than 7200 rpm is installed in Bay 5
or 6.
To remove the fan:
1.
Perform the service preparations shown on page 3-2.
2.
Remove the side access panel.
3.
Disconnect the power cable.
Figure 3-33. Disconnecting the power cable