Filter
Top Products
4-22 Diagnostic Tools
Computer Setup Features
Continued
Task Computer Setup Selection
Set the printer mode (flexible/standard). Click
Built-in Devices,
then click
Communications.
Under
Parallel Port,
select the appropriate
Bi-directional Port.
Set the Num Lock state at power-on. Click
Built-in Devices,
then click
Input Devices.
Under
Keyboard,
turn on
Num Lock State At Power-on.
Disable energy saver mode. Click
Built-in Devices,
then click
Power Management.
Select
Energy Saver Disabled.
Select timeout values.
NOTE: These selections appear only the when energy
saver mode is set (default).
Click
Built-in Devices,
then click
Power Management.
Under
Hard Drive
and/or
Monitor
, select the
Timeout
value.
Enable/disable power LED blink in suspend mode
NOTE: This selection does not appear if the energy saver
mode is disabled.
Click
Built-in Devices,
then click
Power Management.
Select
Blink LED during Energy Saver.
Enable the Power-On Password. Click
Built-in Devices,
then click
Security Management.
Under
Power-On Password,
click
Set.
Enable/disable keyboard QuickLock, QuickBlank screen
when locked, and QuickLock in energy saver mode.
NOTE: These selections appear only if a Power-On
Password is set.
Click
Built-in Devices,
then click
Security Management.
Under
Power-On Password,
select the appropriate options.
Enable the Setup (administrator) Password. Click
Built-in Devices,
then click
Security Management.
Under
Setup Password,
select
Enable Setup Password.
View current settings of Plug and Play (PnP) devices and
set resources for installed boards.
Click
Integrated and Add-in Devices,
then click
ISA Boards.
View the currently installed PCI devices and view and/or
reconfigure settings (IRQ, I/O, DMA, memory).
Click
Integrated and Add-in Devices,
then click
PCI Boards.
Enable/disable the SCSI controller boot order for Compaq
SCSI options.
Click
Integrated and Add-in Devices,
then click
PCI Boards.
Under
SCSI Controller Boot Order,
select
Enable Boot Order.
Enable/disable PCI bus mastering, PCI VGA palette
snooping, and interrupt sharing.
Click
Integrated and Add-in Devices,
then click
PCI Boards.
Under
System Options,
select the appropriate options.
Restore factory default settings and exit Computer Setup. Select
File,
then select
Set Defaults and Exit.
Exit Computer Setup without applying or saving any
changes.
Select
File,
then select
Exit Without Saving Changes.
Save changes to the system configuration and exit
Computer Setup.
Select
File,
then select
Save Changes and Exit.