Filter
Top Products
122 Adding and Replacing Parts
Hinge Cover
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
1
Follow the procedures in "Before You Begin" on page 111.
2
Remove the hinge cover.:
a
Open the display all the way (180 degrees) so that it lies flat against
your work surface.
NOTICE: To avoid damage to the hinge cover, do not lift the cover on both sides
simultaneously.
b
Insert a scribe into the indent to lift the hinge cover on the right side.
c
Ease the hinge cover up, moving from right to left, and remove it.
NOTE: When replacing the hinge cover, first insert the left edge and then press
from left to right until the cover snaps into place.
book.book Page 122 Tuesday, July 3, 2007 12:31 PM