Filter
Top Products
60 Using Cards
To install an ExpressCard:
1
Hold the card with the top side of the card facing up. The latch may need
to be in the "in" position before you insert the card.
2
Slide the card into the slot until the card is completely seated in its
connector.
If you encounter too much resistance, do not force the card. Check the
card orientation and try again.
The computer recognizes the ExpressCard and automatically loads the
appropriate device driver. If the configuration program tells you to load the
manufacturer's drivers, use the floppy disk or CD that came with the
ExpressCard.
1 ExpressCard
1
book.book Page 60 Tuesday, July 3, 2007 12:31 PM