Filter
Top Products
Jumpers and Switches C-5
D
isabling a Forgotten Password
The computer’s software security features include a
supervisor password and a user password, which are dis-
cussed in detail in Chapter 4, “Using the System Setup
Program,” of the system User’s Guide. A password jumper
on the system board enables these password features or
disables them and clears any password(s) currently in
use.
To disable a forgotten supervisor password or user pass-
word, a trained service technician must perform the
following steps:
1. Remove the computer covers.
See “Removing the Computer Covers” in Chapter 7
for instructions.
2. Refer to “Jumpers and Switches—A General
Explanation” found earlier in this appendix for
jumper information.
Figure C-1 shows the location of the password
jumper (labeled “PSWD”) on the system board.
3. Remove the jumper plug from the PSWD jumper.
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list.
Table C-3. SCSI Backplane Board Connectors
Connector Description
DRIVEn Hard-disk drive carrier connector
PANEL Control panel connector
POWER Power input connector
SCSI Ultra/Wide SCSI cable connector
SMB Server-management bus connector
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list.
Table C-2. System Board Connectors and Sockets
(Continued)
Connector or Socket Description
CAUTION: See “Protecting Against Electro-
static Discharge” in the safety instructions at
the front of this guide.