Filter
Top Products
3-4 Dell PowerEdge 4100/180 and 4100/200 Systems Installation and Troubleshooting Guide
Stepping of CPU2
is less than sA1
- System halted!
A Pentium Pro micro-
processor that is not
supported by the system
is installed in the
PROCESSOR2 socket.
Replace the microprocessor with a correct version of the Pen-
tium Pro microprocessor from Dell. See “Upgrading the
Microprocessor or Installing a Secondary Microprocessor” in
Chapter 8 for details.
Stepping of CPU
is less than sA1
- System halted!
A Pentium Pro micro-
processor that is not
supported by the system
is installed.
Replace the microprocessor with a correct version of the Pen-
tium Pro microprocessor from Dell. See “Upgrading the
Microprocessor or Installing a Secondary Microprocessor” in
Chapter 8 for details.
Nonidentical
CPUs - System
halted!
The cache memory size
of the two Pentium Pro
microprocessors must
match.
Replace one of the microprocessors so that the cache size of
the two microprocessors matches. See “Upgrading the Micro-
processor or Installing a Secondary Microprocessor” in
Chapter 8 for details.
Invalid CPU
speed detected -
Check speed
jumpers. System
halted.
The microprocessor
speed detected is not
180 MHz or 200 MHz.
Check the microprocessor speed jumpers. See Table C-1.
Power supply
paralleling
board firmware
download failed
System back-
plane firmware
download failed
The server-management
bus cable connection to
the SCSI backplane
board may be loose,
preventing the firmware
from downloading dur-
ing system start-up.
Check the server-management bus cable connections to the
system board (labeled “SMB BACKPLANE”) and SCSI
backplane (labeled “SMB”).
Embedded server
management firm-
ware download
failed
The embedded server
management memory
may be temporarily cor-
rupted.
Turn off the system to clear the memory, then restart the sys-
tem.
Table 3-1. System Messages
(Continued)
Message Cause Action
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list.