Filter
Top Products
System Setup Utility 133
4
Remove the rear I/O cover. See "Removing the Rear I/O Cover" on page 39.
5
Remove the side I/O cover. See "Removing the Side I/O Cover" on page 41.
6
Remove the system-board shield. See "Removing the System-Board
Shield" on page 53.
7
Locate the 3-pin password reset jumper (PASSWORD_CLEAR) on the
system board. See "System Board Components" on page 17.
8
Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
9
Wait for approximately five seconds to clear the password setting.
10
Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2
and 3.
book.book Page 133 Thursday, May 3, 2012 1:21 PM