Filter
Top Products
System Setup Utility 135
7
Locate the 3-pin password reset jumper (CMOS_CLEAR) on the system
board. See "System Board Components" on page 17.
8 Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and
2.
9
Wait for approximately five seconds to clear the CMOS setting.
10
Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2
and 3.
11
Replace the system-board shield. "Replacing the System-Board Shield" on
page 54.
12
Replace the rear I/O cover. See "Replacing the Rear I/O Cover" on page 40.
13
Replace the side I/O cover. See "Replacing the Side I/O Cover" on page 41.
book.book Page 135 Thursday, May 3, 2012 1:21 PM