Filter
Top Products
29D-Link DSL-2770L User Manual
Section 3 - Conguration
Select PPPoE (Username/Password) from the drop-down menu.
Enter your PPPoE username.
Enter your PPPoE password and then retype the password in the next
box.
Enter the ISP Service Name (optional).
Enter the IP address assigned to you by your Internet Service Provider.
Enter the Primary and secondary DNS server IP addresses assigned by
your ISP. These addresses are usually obtained automatically from your
ISP. Leave at 0.0.0.0 if you did not specically receive these from your ISP.
The default MAC Address is set to the Internet port’s physical interface
MAC address on the Broadband Router. It is not recommended that
you change the default MAC address unless required by your ISP. You
can use the Clone button to replace the Internet port’s MAC address
with the MAC address of your Ethernet card.
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your specic ISP. 1492 is the default MTU.
Check this box if you want the router to use NAT to provide IP addresses
for your computers and devices. If this is disabled, your devices will need
to get IP addresses from your ISP or congured individually.
My Internet
Connection:
Username:
Password:
Service Name:
IP Address:
Primary/
Secondary DNS
Server:
MAC Address:
MTU:
Enable NAT:
PPPoE (Username/Password)
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.