Filter
Top Products
77D-Link DSL-2770L User Manual
Section 3 - Conguration
Routing
Select this box to enable routing, then select which routing protocol
to use:
• RIPv1: Protocol in which the IP address is routed through the
internet.
• RIPv2: Enhanced version of RIPv1 with added features such
as Authentication, Routing Domain, Next Hop Forwarding, and
Subnet-mask Exchange.
This identies the rule.
Enter in the IP of the specied network that you want to access using
the static route.
Enter in the subnet mask to be used for the specied network.
Enter in the gateway IP address for the specied network.
Enter in the amount of hops it will take to reach the specied network.
Note: In a transmission path, each link is terminated at a network device
such as a router or gateway. The number of hops equals the number
of routers or gateways that data must pass through before reaching
the destination.
Select this box to enable the rule.
RIP:
ID:
Destination:
Subnet Mask:
Gateway:
Hop:
Enable:
The Routing page allows you to specify custom routes that determine how data is moved around your network. After modifying
any settings, click Save Settings to save your changes.