Filter
Top Products
28
Installation and settings (Windows)
fig.syn*
1
Press the
SOFTWARE
SYNTHESIZER
button to turn it on
(lit).
The PC-80’s display will indicate
“SYN,” and it will be in Soft Synth
mode.
The computer screen will show the
PC-80 software synthesizer screen
(Synth panel).
2
When the Synth panel appears, try playing the PC-80’s keyboard.
If the installation was done correctly, you will hear sound from the PC-80’s
built-in speakers (or from the headphones if connected) when you play the
PC-80’s keyboard.
3
To exit Soft Synth mode, press the
SOFTWARE SYNTHESIZER
button once
again to turn it off.
Starting up the PC-80 software synthesizer
You can’t start up the PC-
80 software synthesizer if
the PC-80 is not connected
to your computer via USB.
USB cable
AC adaptor
Set the power switch to the DC position,
and connect the AC adaptor.
AC adaptor
If the Synth panel does not
open, refer to the Trou
leshooting section “Won’t
start up” (p. 121).
If you don’t hear sound,
refer to the
Troubleshooting section
“No sound” (p. 122).
About the PC-80’s built-in
speakers
Depending on your system,
you may experience
problems such as a poor S/
N ratio for the audio when
using the PC-80’s built-in
speakers. If so, you can take
the following measures.
• Lower the master volume.
• Turn the PC-80’s built-in
speakers off (use
headphones)
• Connect the AC adaptor
and set the power switch
to the DC position
PC-80_e.book 28 ページ ２００５年１１月１０日 木曜日 午前１１時３４分