Filter
Top Products
93
System settings for the PC-80
6
Press the
ENTER
button.
The Key Velocity mode specifies whether velocity values will be transmitted according to the
keyboard sensitivity you specified in
“VELOCITY CURVE”
(p. 92) or at a single fixed value.
The PC-80 detects the force with which you strike each key and transmits this as the velocity
value, but you can set the Key Velocity mode to a fixed value so that the same value will be
transmitted each time, regardless of how strongly (or softly) you strike the key. If you don’t
want your playing dynamics to affect the sounds you play, proceed as follows to set the Key
Velocity mode to a fixed value.
fig.util*
1
Simultaneously press the
MIDI CH
button and
PGM CHANGE
button,
and hold them down for a few moments.
The PC-80’s display will indicate “UTL,” and you will be in Utility mode.
fig.sy0
2
Press the
[SYSTEM]
key on the keyboard.
“SY0” appears (blinking) in the display.
3
Use the
VALUE
encoder or the
[3]
key of the keyboard to choose “
SY3
.”
fig.enter
4
Press the
ENTER
button.
* If you press any other button without pressing the ENTER button, the setting will be
cancelled.
5
Use the
VALUE
encoder or the
keyboard
to specify the Key Velocity mode.
6
Press the
ENTER
button.
* If you change the Key Velocity in Controller mode, that value will take priority.
* The value you specify here will take effect the next time the PC-80 is powered up.
KEY VELOCITY
Key
Display Mode Explanation
0 TOUCH
Velocity values will be transmitted according to the keyboard sen-
sitivity and curve you selected in
“VELOCITY CURVE”
(p. 92).
1–127
Fixed value
Velocity will be transmitted at the specified value regardless of
how strongly you play the keyboard.
Velocity Curve setting
You can also access the Velocity Curve setting screen by holding down the VELO CRV button
while you turn on the power.
PC-80_e.book 93 ページ ２００５年１１月１０日 木曜日 午前１１時３４分