Filter
Top Products
95
System settings for the PC-80
Here’s how to assign a specified parameter to the VALUE encoder.
* The assignment of the VALUE encoder is valid only in
Play mode
(p. 60) and in
Controller mode
(p. 67).
fig.util*
1
Simultaneously press the
MIDI CH
button and
PGM CHANGE
button,
and hold them down for a few moments.
The PC-80’s display will indicate “UTL,” and you will be in Utility mode.
fig.sy0
2
Press the
[SYSTEM]
key on the keyboard.
“SY0” appears (blinking) in the display.
3
Use the
VALUE
encoder or the
[5]
key of the keyboard to choose “
SY5
.”
fig.enter
4
Press the
ENTER
button.
* If you press any other button without pressing the ENTER button, the setting will be
cancelled.
5
Use the
VALUE
encoder or the keyboard to specify the parameter.
VALUE ENCODER
Specified parameter
This setting lets you transmit a specified parameter by turning the PC-80’s VALUE encoder.
To transmit the parameter value
When you operate the VALUE encoder in What is Controller mode? (p. 67), the
corresponding value for the parameter you specified will be transmitted.
“Using the VALUE encoder to transmit values for a specified parameter” (p. 78)
PC-80_e.book 95 ページ ２００５年１１月１０日 木曜日 午前１１時３４分