Filter
Top Products
EPSON Stylus PHOTO 810/820/830 Revision B
Disassembly and Assembly Disassembly 121
10. Remove the Ink system unit (Cap unit and Pump unit) carefully.
.
11. Remove four gears (Combination gear 16.32, Spur gear 25.6 with the Change
lever, Spur gear 27.2, Combination gear 18.28) and the Pump pulley, and get out
of the ink tube from the Ink system frame.
12. Remove the Waste drain ink pad under the Cap unit from the Lower housing.
CAUTION
When removing the Ink system unit, be careful so that the gears
do not come off from each shaft of the Ink system frame.
CHECK
POINT
When getting out of the ink tube, check the marking on the ink
tube in advance.
Figure 4-62. Marking position on the Ink tube
Ink tube
When assembling as the Cap unit,
Do not touch the sealing rubber portion and the Cleaner
head of the Cap unit.
Be careful not to crash or leave any stress on the Ink tube.
Make sure to set the marking position of the ink tube as
shown figure below.
Figure 4-63. Pump tube setting position
Wiper
Marking position