Filter
Top Products
152 Options and Consumables
Paper handling
This section describes how to use the perforation cutter with
continuous paper. Before printing with the perforation cutter
installed, set the page length to match your paper using your
software or the SelecType mode. See “Changing the settings in
the SelecType mode” on page 98 for details.
Note:
❏ EPSON recommends that the perforation between pages is folded
when using the perforation cutter.
❏ The last page may not be ejected completely. If this happens, gently
pull it out of the printer.
❏ The perforation cutter can not cut the last 11 inches of continuous
paper, but you can print on it.
Cutting off a printed document
You can cut off a printed document using one of the following
methods:
❏ If you set the cutting method through the printer driver, the
printer driver setting overrides the SelecType settings.
You can select the following from the printer driver’s paper
source settings:
Tractor Front: Do not cut
Tractor Front: Cut last page only
Tractor Front: Cut each page
Tractor Rear: Do not cut
Tractor Rear: Cut last page only
Tractor Rear: Cut each page
❏ Set the Auto cut mode setting to On in the SelecType mode.
See “Changing the settings in the SelecType mode” on page
98 for instructions.