Filter
Top Products
Paper Handling 41
2
2
2
2
2
2
2
2
2
2
2
2
The DFX-9000 can print on multi-part forms that vary in
thickness, such as forms with labels on them or forms that overlap
slightly where they are glued together. These forms are thicker in
the label area and in the places where they overlap or are joined
together, as shown below. When you use forms with labels, set
the Continuous forms with labels setting to On. When you use
overlapping multi-part forms, set the Overlapping multipart
forms setting to On and the Platen gap setting to 0 to 14 according
to the paper thickness you are using. See “Changing the settings
in the SelecType mode” on page 98 for details.
c
Caution:
Be sure to set the Overlapping multi-part forms setting or
Continuous forms with Label setting to On before you print on
the respective forms. See “Changing the settings in the SelecType
mode” on page 98 for instructions.
When you print on these forms, make sure that the printing fits
within the printable area and that the top-of-form position is set
properly. See “Paper” on page 171 for more information about the
printable area.
Overlapping multi-part forms
Continuous forms with labels