Filter
Top Products
EPSON EPL-6200/EPL-6200L Revision A
Product Description Control Panel (EPL-6200L) 52
Front Cover Open
Description
Font printer cover is open.
This error is cleared when the cover is not detected to be open any longer.
Remedy
When the cover is closed, the error is cleared, and the pop-up display of the
EPSON Status Monitor disappears accordingly.
Exit Cover Open
Description
Output Cover is open.
This error is cleared when the cover is not detected to be open any longer.
NOTE:
The printer displays an Exiting Paper Jam status if the Output
Cover is open at power on.
Remedy
When the cover is closed, the errors disappear, and the pop-up display of the
EPSON Status Monitor disappears accordingly.
Paper Set
Description
Since the paper size specified by Paper Size setting differs from the paper size
recognized by the size detected by printer itself, operation stops before
printing.
The Continue command of the ESCPAGES-02 protocol clears the error in the
printer engine, and the error in the printer is cleared accordingly. The
ResetPrinter command releases the error in the printer engine resetting the
printer to the initial status.
This error does not occur when the specified paper size is an undefined paper
size, and when “Size Ignore = ON” or “Auto Continue=ON” is selected. This
error occurs only once in one document.
Remedy
Insert appropriate paper, and select [Continue] on the EPSON Status Monitor.
To reprint after modifying driver settings, select [Cancel Printing] on the
EPSON Status Monitor.
Invalid Size
Description
Since an unsupported paper size was specified or a different feeding direction,
such as A4 Long Edge Feed, was selected, operation stopped before printing.
The Continue command of the ESCPAGES-02 protocol clears the error, and
printing resumes from the next page. When “Auto Continue = ON” this error
dose not occur and the page is printout.
Printing will be achieved if the printer driver can clip the image to A4.
Therefore, this error will not occur when you use a proper printer driver.
Remedy
To print pages after “Invalid Size”, select [Continue] on the EPSON Status
Monitor.
To reprint after modifying driver settings, select [Cancel Printing] on the
EPSON Status Monitor.
Print Underrun
Description
Data was not sent from the host during processing of a document and time-out
occurred. Then printing began, but the band data is insufficient. Resetting the
printer to the initial status by the ResetPrinter command of the ESCPAGES-
02 protocol clears the error.
When “Auto Continue = ON” is set and printer can not printout the page
“Print Failure” is displayed instead of the error, and resumes printing the next
page.
This error does not occur when “Auto Continue=ON” or “Avoid Page Error =
ON” is selected.
Remedy
If data receiving is not completed, selecting [Reprint] on the EPSON Status
Monitor performs printing successfully in some cases, as a result that the
printer driver resends data without a flying start.
To reprint after modifying driver settings, select [Cancel Printing] on the
EPSON Status Monitor.
Mem Overflow
Description
Printing was not successful since the data for one page was not saved due to
insufficient memory at printing operation without flying-start or printing was
not successful because of insufficient memory at a flying start resulting from