Filter
Top Products
CHAPTER 2 Before Using the REMCS Service
2.1 Overview of Connection to the REMCS Center
3
C122-E180-01EN
Before Using the REMCS CHAPTER 2
Service
This chapter describes the connection to the REMCS center, which is required during use of the REMCS
service.
2.1 Overview of Connection to the REMCS Center
The connection configuration for connecting to the REMCS Center depends on the network configuration
and server configuration of the user. The connection configuration to be used must be determined
beforehand.
The PRIMEQUEST 2000 Series supports the following connection configurations. All of these connection
configurations use only SMTP to communicate with the REMCS Center.
- Internet connection (e-mail)
- P-P connection (ISDN: e-mail)
Field engineers make the setting for connecting to the REMCS Center.
2.2 Connection Configuration for Connecting to the REMCS
Center
This section explains the connection configurations for connecting to the REMCS Center.
The following connection configurations are available.
- 2.2.1 Internet connection (e-mail)
- 2.2.2 P-P connection (ISDN: e-mail)
2.2.1 Internet connection (e-mail)
This connection configuration is used for communication with the REMCS Center via the Internet.
Using a network connected to the user port
FIGURE 2.1 Internet connection (using the network connected to the user port) shows a configuration that
uses a network connected to the user port.
Remarks
If the SMTP server at the customer site is specified with the FQDN, the DNS to be referred to by the MMB
must be set. If the SMTP server is specified with the IP address, this setting is not required
.