Filter
Top Products
CHAPTER 3 REMCS Service Start Procedure
3.2 REMCS Center Registration
12
C122-E180-01EN
FIGURE 3.5 [Internet(Mail Only) connection environment settings] window
1. Enter the values for the following items.
TABLE 3.1 Input items for the [Internet(Mail Only) connection environment settings] window
Item
Description
SMTP Server
Enter the SMTP server name or IP address in single-byte
alphanumeric characters and symbols.
Sender E-mail Address
Enter the sender e-mail address in single-byte alphanumeric
characters and symbols.
Authentication type
Select the authentication type from [No certification], [POP Before
STMP], and [AUTH STMP].
AUTH SMTP type
Valid if you specified the authentication type [AUTH SMTP].You can
select from [AUTO (initial value)], [CRAM-MD5], [PLAIN], and
[LOGIN].
UserID
Enter the user ID for the authentication server in single-byte
alphanumeric characters and symbols.
Password
Enter the password for the authentication server in single-byte
alphanumeric characters and symbols.
POP Server
If you specified the authentication type [POP Before STMP], enter
the POP server name or
IP address in single-byte alphanumeric characters and symbols.
Division method
Select the division method from [No division], [Mail division], and
[Event division].
The initial value at new installation is [Event division]. The initial
value at the firmware update time is the setting before the firmware
update.
Division Size
Enter the partitioning size in the range of 10 to 100 Kbytes. The
initial value is 64 Kbytes.
Encryption type
If the S/MIME format is not supported before the firmware update,
the initial value is [Previous encryption]. The initial value at the
firmware update time is the setting before the firmware update.
2. Click the [Next] button.
After the connection configuration is registered, the window shown in FIGURE 3.7 [Periodical
Connection settings] window appears.