Filter
Top Products
CHAPTER 4 REMCS Service Operations
4.2 REMCS Service Menu
29
C122-E180-01EN
4.2.6 Connection type change
Use this menu item to change the current connection configuration to another configuration.
1. From the menu in the window shown in FIGURE 4.1 [REMCS initial] window, click [Connection type
change].
The [Connection type change] window (shown in FIGURE 4.6 Window for changing the active
connection configuration) appears.
2. After changing the connection configuration, click the [Next] button. The current setting information is
discarded and the machine status becomes [Setting not completed].
You need to perform the service start procedure by specifying the connection information again
according to 3.2.2 Setting the connection configuration.
FIGURE 4.6 Window for changing the active connection configuration
4.2.7 Displaying the certificate
Use the following procedure to confirm the information of the certificate.
1. From the menu in the window shown in FIGURE 4.1 [REMCS initial] window, click [Display of certificate].
The window will appear according to following cases:
- FIGURE 4.7 [Display of certificate] window (with certificate not replaced)
- FIGURE 4.8 [Display of certificate] window (during use of certificate that has been replaced)
- FIGURE 4.9 [Display of certificate] window (Certificate that has been displayed – previous certificate)
- Window displayed when the certificate has not been replaced