Filter
Top Products
CHAPTER 4 REMCS Service Operations
4.2 REMCS Service Menu
32
C122-E180-01EN
2. Specify the certificate file and then click the [Next] button.
FIGURE 4.11 [Confirmation of certificate] window
3. Confirm the display contents and, if they are acceptable, click the [Next] button.
If you do not intend to replace a certificate, click the [Cancel] button.
4. The following confirmation message is displayed."The certificates will be replaced. Once the replacement
of certificates proceeds, the report to the REMCS center will not be done until connected confirmation is
completed. Are you sure?"
If this is acceptable, click the [OK] button.
5. The machine status display becomes [UNUSED] and the [Connection check] window appears. Upon
confirmation, [ACTIVE] becomes effective.
4.2.9 Restoring a certificate
Use the following procedure to return to the previous certificate from the replacement certificate.
1. From the menu in the window shown in FIGURE 4.1 [REMCS initial] window, click [Replacement to the
previous certificate].
The window shown in FIGURE 4.12 [Replacement to the previous certificate] window appears.
FIGURE 4.12 [Replacement to the previous certificate] window