Filter
Top Products
CHAPTER 4 REMCS Service Operations
4.2 REMCS Service Menu
33
C122-E180-01EN
2. Confirm the content of the <<Restored certificate>> and then click the [Next] button.
If you do not wish to restore the certificate, click the [Cancel] button.
3. The following confirmation message appears. "The certificates will be replaced. Once the replacement of
certificates proceeds, the report to the REMCS center will not be done until connected confirmation is
completed. Are you sure?" If this is acceptable, click the [OK] button.
4. The machine status becomes [UNUSED], and the [Connection check] window appears. Upon
confirmation, [ACTIVE] becomes effective.
4.2.10 Connection check
Use this menu item to check the connection to the REMCS Center.
1. From the menu in the window shown in FIGURE 4.1 [REMCS initial] window, click the [Connection check]
button.
The [Connection check] window (the window shown in FIGURE 4.13 [Connection check] window (without
personal information deleted) or FIGURE 4.14 [Connection check] window (with personal information
deleted) appears.
2. Confirm the setting of the receivers of the connection results and click the [Check] button.
FIGURE 4.13 [Connection check] window (without personal information deleted)