Filter
Top Products
Chapter 19 DDC Replacement 19-5
5. Remove the DDC to be replaced.
a. Using a Phillips screwdriver, turn the knob screw securing the bottom
eject/lock lever 90 to 180 degrees to unlock the lever. (Turn the knob screw
while lightly pulling the lever with one hand.)
b. Unlock the eject/lock levers to pull the DDC off the backplane.
c. While grasping the eject/lock levers, pull out the DDC slowly from the slot.
FIGURE 19-3 Removing the DDC (Front of the M8000)
6. Place the removed DDC on an antistatic mat.
1
2
1