Filter
Top Products
Peripheral/adapter problems 95
Peripheral/adapter problems
The system does not recognize a SCSI device.
The system does not recognize an adapter card.
Probable cause Solution
Thedeviceneedstobe
added as new hardware
In the Control Panel window (Start | Settings |
Control Panel), double-click Add New
Hardware. Follow the on-screen instructions
for adding the device.
The SCSI ID may be invalid Assign an available SCSI ID to the device.
The SCSI chain is not
properly terminated
MakesurethelastdeviceontheSCSIchain
is terminated.
Thedevicecablesarenot
installed correctly
Open the system and check all cables
between the controller and the device. Install
the cables correctly if necessary.
Probable cause Solution
The interrupt or I/O address
is set incorrectly
Check the address configuration of the adapter
card and make sure that it does not conflict
with another card in the system.
The card was not configured
through the software
Configure the card with the appropriate
software.
The card was not installed
correctly
Make sure that the jumpers are configured
correctly, then reseat the card.
05032.book Page 95 Monday, July 10, 2000 11:43 AM