Filter
Top Products
Replacing or adding drives 29
7
Set the drive jumpers to the appropriate settings (refer to your drive
documentation for jumper settings).
8 Align the rails with the open bay, then slide the drive into the chassis
until the locking tabs snap into place.
9 Connect the power and data cables to the back of the drive.
10 Close the case by following the instructions on page 20.
11 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
12 Run the configuration software, if necessary.
05032.book Page 29 Monday, July 10, 2000 11:43 AM