Filter
Top Products
Replacing or adding drives 31
5
Remove the metal EMI shield from the front of the drive bay, if installed,
by placing a finger in the hole on the left side of the shield and pulling
out to disengage it from the chassis.
6 Snap the rails onto the drive, making sure the front rail extensions are
to the front of the device.
Caution Your system was designed to adhere to electromagnetic
interference requirements and the shield is an integral part
of the system. Installing an approved device should
continue to maintain those standards. If you remove the
device you should reinstall the shield.
Pull out on the
left side of the
metal EMI shield
Metal EMI
shield
05032.book Page 31 Monday, July 10, 2000 11:43 AM