Filter
Top Products
46 Replacing and Adding System Components
5 Insert the bottom edge of the expansion card (the keyed edge with the
contacts) into the slot on the system board and push in firmly to seat
the card.
6 After seating the card firmly, use the screw you removed to secure the
card to the rear of the chassis.
7 Connect cables to the card, if required.
8 Close the case by following the instructions on page 20.
9 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
You may need to reconfigure your system after installing some expansion
cards. You may also need to install software that came with the card. Check
the card documentation for additional information.
Screw
05032.book Page 46 Monday, July 10, 2000 11:43 AM