Filter
Top Products
Replacing the system fans 61
To install the new front system fan:
1 Place the new front system fan into the recess in the front of the bottom
drive cage. Orient the fan with the label toward the inside of the chassis
(toward the system board) and the fan power cable to the right of the
drive cage.
2 Secure the fan to the drive cage with the four screws previously removed.
3 Place the bottom drive cage into the chassis under the middle drive cage
and slide it forward so that the support tabs on top of the bottom cage
engage the middle drive cage. Slide the bottom drive cage right to align
the screw holes with the holes on the front of the chassis.
4 Secure the drive cage with the four screws previously removed. Make sure
to correctly route the fan power cable.
5 Replace the plastic card guide and any expansion cards removed
previously.
6 Replace the hard drives into the bottom drive cage.
7 Reconnect the data and power cables on the hard drives.
8 Plug the fan power cable into the appropriate connector on the system
board.
9 Replace the bezel, then close the case by following the instructions on
page 20.
10 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
05032.book Page 61 Monday, July 10, 2000 11:43 AM