Filter
Top Products
26 Replacing and Adding System Components
6 Disengage the rail locking tabs by pressing inward on both front rail
extensions, then move the drive slightly out of the bay by pushing on
the back of the drive. Pull the drive out of the chassis.
7 Remove the rails on both sides of the drive and snap them onto the new
drive in the same positions. Make sure the front rail extensions are
towards the front of the drive.
8 Set the drive jumpers to the appropriate settings (refer to your drive
documentation for jumper settings).
9 Align the rails with the appropriate open bay, then slide the drive into
the bay until the locking tabs snap into place.
10 Connect the power and data cables, making sure the cables are in their
original positions.
11 Close the case by following the instructions on page 20.
12 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
Important The rails on the 3.5-inch drive are different from those on
the CD drive. Make sure you install the correct rails on
each drive.
L
R
3.5-inch
diskette drive
CD drive
05032.book Page 26 Monday, July 10, 2000 11:43 AM