Filter
Top Products
64 Replacing and Adding System Components
Replacing the control/LED board
To remove the control/LED board:
1 Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2 Remove the left side cover panel. (See “Removing the side cover” on
page 18 and “Preventing static electricity discharge” on page 15.)
3 Remove the bezel, as described in “To remove the bezel” on page 19.
4 Remove the system fault LED reset switch button cover.
Screw
System fault
LEDresetswitch
button cover
05032.book Page 64 Monday, July 10, 2000 11:43 AM