Filter
Top Products
56 Replacing and Adding System Components
7 Remove the two supporting screws securing the power supply to the top
of the chassis.
8 While supporting the power supply with one hand, remove the two
screws securing the power supply to the rear of the chassis, then carefully
lift the power supply out of the chassis.
To install the new power supply:
1 Before installing the new power supply, verify that it matches the one
you previously removed. The mounting holes should line up correctly,
and the specifications and power output connectors should be the same.
2 Make sure that the red voltage switch on the back of the new power
supply is set to the proper voltage for your area.
3 Place the new power supply in position in the chassis and line up the
mounting holes with the holes in the chassis. Note that alignment pins
in the chassis go into mounting holes in the rear of the power supply.
4 Replace the two screws securing the power supply to the back of the
chassis, leaving them slightly loose.
Screws
Screws
05032.book Page 56 Monday, July 10, 2000 11:43 AM