Filter
Top Products
Configuring IP Addressing
Configuring a Single Source IP Address
Displaying the Source IP Interface Information
There are several show commands that can be used to display information
about the source IP interface status.
Syntax
:
show ip source-interface status [radius | tacacs | syslog]
Displays the operational status information for the source IP
address selection policy. Both the administratively-assigned
source IP selection policy and the operational source IP
selection policy are displayed.
When no parameters are specified, policy information for all
protocols is displayed.
ProCurve(config)# show ip source-interface status
Source-IP Status Information
Protocol | Admin Selection Policy Oper Selection Policy
-------- + ----------------------- -----------------------
Tacacs | Configured IP Interface Configured IP Interface
Radius | Configured IP Address Configured IP Address
Syslog | Configured IP Interface Outgoing Interface
Figure 8-17. Example of the Data Displayed for Source IP Interface Status
When executing the show ip source-interface command without parameters,
the configured IP interfaces (VLANs) and IP addresses are displayed for each
protocol.
ProCurve(config)# show ip source-interface
Source-IP Configuration Information
Protocol | Admin Selection Policy IP Interface IP Address
-------- + ----------------------- -------------- --------------
-
Tacacs | Configured IP Interface vlan 22 10.10.10.4
Radius | Configured IP Address vlan 3 10.10.10.2
Syslog | Configured IP Interface vlan 10 10.10.10.10
Figure 8-18. Example of show ip source-interface Command Output
8-29